Aren't Raceland coilovers supposed to make all kinds of horrible popping noises?

 

Check to see if the washer between the upper spring perch and strut mount is installed. That noise is from the strut mount bearing not seated correctly so the mount makes contact with the spring perch causing the spring to rotate on the coilover itself. Or it just might be Cause Raceland.

 

the poping is the system clicking into sport mode, it means you will be able to corner faster and harder, push it to the limit

 

endlinks? i had issues with mine being lose.

 

The popping noise is your coil over saying, "I'm a piece of sh1t".

 

The passenger side is perfect. There's something I don't on different I guess. Is there supposed to be a washer between the top hat of coilovers and the strut mount?

Sent from my SCH-I500 using Bimmer App

 

And once that sound is fixed ill be very pleased with these coilovers.



Sent from my SCH-I500 using Bimmer App

 

Bump.
Need to figure out if I need the washer or not?

Sent from my SCH-I500 using Bimmer App

 

Sorry bro just got back from SEMA:thumbsup:. Yes you do need that washer in there. It's part #5 and 6 and goes between the upper strut mount and upper spring perch. http://realoem.com/bmw/showparts.do?model=ET37&mospid=47720&btnr=31_0408&hg=31&fg=10

 

I just can't find this popping. Almost sounds more like spring binding. I checked over everything, strut mount bearing seems good. Any ideas?

Sent from my SCH-I500 using Bimmer App

 

have you checked to make sure you endlinks aren't lose?

 

Yeah double checked all bolts/nuts everythings tight.

Sent from my SCH-I500 using Bimmer App

 

dont race lands need short endlinks to begin with?

 

That binding noise is because your strut bearing isn't pressing on the center of the bearing allowing the coil-over to rotate freely. You need to put the proper sized washer in there for the noise to go away. Proper size is enough to touch the inner bearing race and not touch the outer race.

 

I used my oem washers. Seems to only touch inner race. Basically covers the size of the bearing dust shield. Note* this is only on one side. This weekend I'm a take it all apart again and start from beginning

Sent from my SCH-I500 using Bimmer App

 

aaand? prob will get these for xmas. cheap ass gf. oh well better than nothing lol

 

:rofl:

 

Popping and clunking going straight and not turning and it's not your end links.

Trying to think back to my race land experience. Front end clunk you either didn't torque your strut mounts down proper or you may have included or excluded a washer between the coilovers and the strut mount.

Unbolt one end link if you want to eliminate end kinks as your culprit. Easiy way of knowing if your preloaded from longer end links than you need. Don't drive like a maniac but try to generate the clunking again. Still clunks and it's something else.

 

Was a missing washer the cause of the clunking/binding noise? I am having the same issue with my RL struts

 

Yeah it was a missing washer. After I fixed that it never made another sound. I enjoyed the coilovers for the price! But if id do it again id hold out for something a tad better quality

Sent from my SCH-I500 using BimmerApp mobile app