E46 Fanatics Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Hey All,

I had an issue with a front turn signal. Finally found that one of the bulb sockets was bad. The funny thing is, the one that was working appeared fine visually, while the contact point on the one that still worked was all crumbed up.

I replaced both bulb sockets with P/N 63 13 6 943 122 and all is well. These new ones also have a little gasket that mates up with the bulb housing that the old ones didn't have.

Cheers!

Rob
 
1 - 1 of 1 Posts
Top