hi all.
im in the middle of the job. my torque wrench is 40-210nm. the nut is torqued to 250nm. i dont wan to buy a new torque wrench cappable of 250nm, they are quite expensive and money is tight at this moment.
i will torque it to 210nm.
is there a way to safely aproach to the torque spec but not overtightening it?
thanks in advance.
im in the middle of the job. my torque wrench is 40-210nm. the nut is torqued to 250nm. i dont wan to buy a new torque wrench cappable of 250nm, they are quite expensive and money is tight at this moment.
i will torque it to 210nm.
is there a way to safely aproach to the torque spec but not overtightening it?
thanks in advance.
