E46 Fanatics Forum banner
1 - 4 of 4 Posts

· Registered
2004 325ci
Joined
·
50 Posts
Discussion Starter · #1 ·
I've tried so hard to search for this. I bought a chase bays extended clutch line but they don't even know what the thread size is or pitch on the male end going into the slave. I am running a T56 magnum transmission trying to adapt its 4an fitting to this line. So just need to know is this a 3 an or something different so I can order a coupler adapter to get then connected. I dont need to know the end going into the pedal part just the other end that I believe goes into slave cylinder. Thanks everyone. They do sell one to a t56 but I have a custom tilton setup so their e46 to t56 line kit doesn't work either for me.
Automotive tire Automotive lighting Bicycle tire Bicycle part Rim
 

· Registered
2004 325ci
Joined
·
50 Posts
Discussion Starter · #6 ·
I found an e36 swap post similar, I'd assume they wouldn't change the pipe size seeing the trans carried over essentially;

points to bubble flare m10x1.0 on the e36 slave
Sweet I will try to order an adapter and see if it works.
 
1 - 4 of 4 Posts
Top