BMW E46 Fanatics Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
77 Posts
Discussion Starter #1
Hello.

The RPM needle is off by about 700 rpm in my car. However it is still functioning. By functioning i mean the needle moves up and down with the revs of the engine.

I have ran the test 2 on the instrument cluster. The needle moved all the way from 700 to almost touching the MPG needs on the other end. It was way past 7000.

Is there a way i can move the needle to the correct position without replacing the whole cluster? thanks Picture of the instrument cluster with the engine off
 

·
Registered
Joined
·
1,016 Posts
Absolutely easy diy. Two torx screws to remove cluster and only a few torx to undo the cluster. Once apart just simply(carefully) remove needle and replace at "0". Done Shouldnt take more than 10 minutes :thumbsup:
 
1 - 2 of 2 Posts
Top