E46 Fanatics Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
I am 90% done with my turbo build. its been going insanely well for putting a cx racing kit on a 330xi wagon! but I have a quick question about the oil system, for the time being I am using the stock oil housing. but I am having problems getting the oil distribution block in and everything too fit. but I did notice I can switch my oil pressure and I think oil temp sensor?

my question is will this cause any problems? my housing normally has the oil pressure switch lower down in the housing and facing the front of the car, the oil temp sensor facing the drivers side headlight. any input would be excellent.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top