E46 Fanatics Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
469 Posts
As for the RTABs, my understanding is to use a long straight-edge or a ruler and press it against the BOTTOM of the RTAB carrier. Then you measure 8mm BELOW the center of the hub and you put your straight edge to this point while pressed flat onto the bottom of the RTAB carrier. Then you tighten your 18mm carrier bolt to spec which I believe is 81 ft-lbs.
It's 8mm ABOVE the center of the hub.

 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top