E46 Fanatics Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hello, I have a problem with an m54b22, I took the intake down in order to replace the vacuum hoses, said and done, working there I noticed that the camshaft sensor on the intake was melted on the block, the car was going well ... I mounted the intake, and I changed the camshaft sensor with a new one ERA AFTERMARKET ... I started the car everything perfectly, I turn and my car goes in 5 pistons ... I thought it was the problem from the coils, I reversed them but he still misses me on cylinder 5 .. He was walking normally until he was cutting the spark at cylinder 5 ... Now he only goes in 5 pistons, the 5 is dead, he doesn't have any electricity at all ... Opinions please! Thank you
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #3 ·
Capul, nu blocul. Dar vă rog să postați o poză cu senzorul topit pentru că nu înțeleg cum se poate întâmpla asta.

Aceasta este o idee proastă. Lăsați senorul topit în pace, funcționează bine.

Verificați de două ori conectorii injectoarelor care au o conexiune bună.
[/CITAT]
Yesterday I started the car, it worked perfectly in idle, after I accelerated it At 6000rpm it started to run in 5! The injector on the 5 is not opened by the DME
 
1 - 2 of 2 Posts
Top