E46 Fanatics Forum banner

Manual swap wiring

2967 Views 13 Replies 4 Participants Last post by  Adam772
Hey all,
Nearing the end of my 5 speed swap but have one last problem. When I removed the automatic shifter it was in drive which was my mistake and was wondering if anyone had insight on the wiring?

I looked through the wiring on other swaps on the forums but could not find any where they had to bypass the neutral safety switch.

Thanks in advance
1 - 1 of 14 Posts
I used NCS to code the whole car as a manual.. I also coded out JUST the clutch safety switch using NCS..which I believe they didn't use in Europe anyway.. The cruise control is separate and should be unaffected.

OP be sue to unplug the EGS computer completely.
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.