E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
5,375 Posts
Discussion Starter · #1 ·
I am putting in kwv2's and have a couple questions b4 I start. And yes I am using the 330i write up. In the write up the pss's are not pre-assembled.... but the Kw's are. However, the kws feel only hand tightened.... is that the way I should install them or does it all need to be torqued down? Any helpfull hints on the install would be great. I have done springs but never coilovers.

Thanks,
Mike
 

·
Registered
Joined
·
356 Posts
The whole assembly will be torqued down when you install the bearing plate from your existing strut unit.
 
1 - 2 of 2 Posts
Top