E46 Fanatics Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
279 Posts
Discussion Starter · #1 ·
Guys,

I'm hookin up my JL 500/1 Amp and have a dilemna. I tapped a switched 12V *********** wire in the rear of the trunk going into the HK amp and ran this wire to the remote port on the back of the JL amp. However, my amplifier install kit (that I purchased at Best Buy) has a thin black ground wire. Where do I attached this to (on the amp?? on the white wire?) Do I tap the 12V wire twice with wire taps and just use the black for a ground??
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top