Isotta shift ring and high gloss black console

1398 Views 15 Replies 8 Participants Last post by negari, Mar 15, 2003

Cyric

Discussion Starter · Mar 14, 2003

I thought I would try a little experimenting with different trims and options, and this is what I came up with. Thoughts, comments, suggestions are welcome.

OEM trim with black leather shift knob:

<img src="http://www.strike9.com/file.aspx?path=/Jeff33/fullsize/46+-+OEM+Myrtle.jpg">

Isotta shift trim and high gloss black shift console trim:

<img src="http://www.strike9.com/file.aspx?path=/Jeff33/fullsize/46+-+Isotta+far.jpg">

Close up:

<img src="http://www.strike9.com/file.aspx?path=/Jeff33/fullsize/46+-+Isotta+close.jpg">

Save

1 - 2 of 16 Posts

jeffnnj

· #12 · Mar 15, 2003

Serbonze said:
It comes with a plastic piece that you sandwich the shift boot between. No drilling in the plastic at all, however you need to trim a bit off of the boot for it to fit properly.

The chrome ring was $20.00 on ebay, the high gloss black trim was $19.99 from my local BMW dealer.

Okay. I received mine today. So you remove the leather boot from the plastic ring. Does the white plastic bezel actually replace the plastic ring that is attached to the leather boot?? If not I don't see how all three will fit and alloe the chrome ring to sit flat. Thanks so much,
Jeff

Save

jeffnnj

· #15 · Mar 15, 2003

jeffnnj said:
Okay. I received mine today. So you remove the leather boot from the plastic ring. Does the white plastic bezel actually replace the plastic ring that is attached to the leather boot?? If not I don't see how all three will fit and alloe the chrome ring to sit flat. Thanks so much,
Jeff

ALSO ON EbAY BUT I THINK THE SELLER IS OUT OF THEM :sad:

Save

1 - 2 of 16 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month