I was trying to remove my transmission and ended up breaking one of the M12 bolts. I now have part of the M12 bolt stuck in my engine block. To make things worse, I tried to drill out the M12 bolt but due to insufficient space, I ended up drilling part of the bolt out at an angle. At this point, i'm not sure how I can take out the remainder of the bolt and then retap the hole without possibly taking out the engine to get sufficient space to properly drill and retap. Attached is a pic of the bolt that is broken. It is the one on the left just below the starter. The close up is the pic of how it is now after trying to drill it out. I tried to use an extractor but since I drilled the hole at an angle, the end of the hole did not make it to the end of the broken bolt but rather just outside of the hole where the bolt is stuck.
109.1 KB Views: 196
80.6 KB Views: 190