E46 Fanatics Forum banner
1 - 3 of 3 Posts

· Say hello to my lito fren
1,033 Posts
Discussion Starter · #1 ·
mt3ch and I just stopped by Exclusive Motoring in Miami to get the fenders rolled....they were showing us what is needed:

1. heat up fender
2. heat up interior of fender to loosen rubber insert in the inner part of fender
3. roll the fender in 2-3 stages...

Is any of this required?:dunno:

sounds like it makes sense, but [email protected] that's a lot of work...and they are charging $120/fender

I know that's a lot of money (twice what it should cost), but want to get some opinions..

btw, these guys were saying that the rubber inserts are for '02 models and above....:dunno:
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.