E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 3 of 3 Posts

3 Posts
Discussion Starter · #1 ·
I had a problem for the past week where the EML and Traction Control would suddenly turn on and throw the car into Limp Mode. The only help I could find in Forums was to check the Wheel Sensor or to check the ECU.

The codes I was getting were P1122 and P1121 which are related to the Pedal Input.

What ended solving the problem was removing the Sprint Booster V3.

I blame it on poor Design. The length of the unit is far too small to store in a safe place so it was stashed somewhere behind the pedal. My guess is that the Pedal was crashed or the delicate wires were damaged. It is possible for the Sprint Booster to cause these faults by its nature but I doubt it.

Hope this helps someone lost like I was a week ago!
1 - 3 of 3 Posts