E46 Fanatics Forum banner
1 - 1 of 1 Posts

snowdogs rule
1,479 Posts
Hello BMW Experts!
I really like the way the OP did this. Using JB Weld to hold the new plate in place sounds good also, since it would not weaken the original metal like a weld or sheet screws would.
The only question I see as unanswered is what thread pitch would engage the original mounting threads (the threaded block between the two layers of the floor) while the bolt is passing through?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.