$5500 firm.
PHOTOS CAN BE FOUND HERE
drive.google.com
I can ship, but prefer local pickup in/near Los Angeles, CA. This is for a E46 chassis with an M54, but 99.99% of these parts will bolt up to a E36 chassis/M5X engine. I will need your stock exhaust manifolds (if going onto an M54) along with your stock exhaust.
Kit includes:
SPA T3 turbo manifold
GTX3584R 1.06 A/R ball bearing (clone)
Vibrant intercooler
PMAS HPX MAF
Bosch 0280158040 injectors with top hats
DW300 fuel pump with upgraded relay harness
TiAL F38 wastegate with various springs
Relocation pipe for wastegate
Full 3" downpipe
Full 3" exhaust with valved muffler (with hangers)
Charge piping that retains ICV and F-connector
Full 4" intake
Will come with a tune (not 100% finalized) for MS43 for full E85
Oil pan with pre-welded bung for proper drain (no scavenge pump required)
Flex fuel sensor (not implemented into MS43 yet but will be eventually)
AEM wideband gauge
TURBOSMART boost gauge
NXS Motorsports manual boost controller
M54 valve cover with B58 coil packs and conversion harness
Unfortunately no clutch as dropping the transmission is too much work.
Everything is currently on my car but I have these pics
This setup is good for about 4-600WHP. The limiting factors is the injectors on E85 around 500WHP. It ran 11s in the 1/4 mile with a soft launch.
Video of it putting in work VID_156110128_211935_785.mp4
ALSO can sell a 8HP45 swap kit (excluding TCU, transmission, and driveshaft. E46 ZF5HP automatic driveshaft is used for this swap) for $2400 OBO.
PHOTOS CAN BE FOUND HERE
Turbo kit - Google Drive
drive.google.com
I can ship, but prefer local pickup in/near Los Angeles, CA. This is for a E46 chassis with an M54, but 99.99% of these parts will bolt up to a E36 chassis/M5X engine. I will need your stock exhaust manifolds (if going onto an M54) along with your stock exhaust.
Kit includes:
SPA T3 turbo manifold
GTX3584R 1.06 A/R ball bearing (clone)
Vibrant intercooler
PMAS HPX MAF
Bosch 0280158040 injectors with top hats
DW300 fuel pump with upgraded relay harness
TiAL F38 wastegate with various springs
Relocation pipe for wastegate
Full 3" downpipe
Full 3" exhaust with valved muffler (with hangers)
Charge piping that retains ICV and F-connector
Full 4" intake
Will come with a tune (not 100% finalized) for MS43 for full E85
Oil pan with pre-welded bung for proper drain (no scavenge pump required)
Flex fuel sensor (not implemented into MS43 yet but will be eventually)
AEM wideband gauge
TURBOSMART boost gauge
NXS Motorsports manual boost controller
M54 valve cover with B58 coil packs and conversion harness
Unfortunately no clutch as dropping the transmission is too much work.
Everything is currently on my car but I have these pics
This setup is good for about 4-600WHP. The limiting factors is the injectors on E85 around 500WHP. It ran 11s in the 1/4 mile with a soft launch.
Video of it putting in work VID_156110128_211935_785.mp4
ALSO can sell a 8HP45 swap kit (excluding TCU, transmission, and driveshaft. E46 ZF5HP automatic driveshaft is used for this swap) for $2400 OBO.
