BMW E46 Fanatics Forum banner

1 - 5 of 5 Posts

·
Banned
Joined
·
713 Posts
Discussion Starter #1
Broke one of my fogs on the driver side of my MTECH bumper. Was just going to go buy a new one and replace it, anyone know how hard this is to do?? Or can send me in the right direction of how to do it so I don't end up fumbling around and breaking something??

thanks
Cavan
 

·
Banned
Joined
·
713 Posts
Discussion Starter #3
hey

Thanks TZ, actually need to replace a broken one (rock hit it square in the center), that is what I needed to know though, sounds easy.

Cavan
 

·
Registered
Joined
·
54 Posts
TZ Blue D3 said:
1) pop off trim ring (pull staight out)
2) unscrew 1 hex screw
3) pull foglight out
4) change the bulb
SIMPLE:brent:
it seems impossible to pull out the ring without breaking it. do i have to remove any other bumper parts b4 pulling out the ring?? :dunno:
 

·
Banned
Joined
·
713 Posts
Discussion Starter #5
bimmerguy2004 said:
it seems impossible to pull out the ring without breaking it. do i have to remove any other bumper parts b4 pulling out the ring?? :dunno:
The ring is only clipped in on mine, just pull out.

Cavan
 
1 - 5 of 5 Posts
Top