E46 Fanatics Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
236 Posts
its pretty easy to remove the harness. just take note of how it wraps through and around it to make installation easier. when you open the door there is a 10mm hexhead that holds the black plastic cartridge in the pillar, the rear doors are easy enough to get to the fronts are a little more awkward. then this is out you can pull the plastic cap out of the door and you can then unslide the 2 sides from each other leaving one end of the plug and the rubber grommet coming from the door itself. Its pretty good in design when you compare it to a jdm car of the last 20 years
 

·
Registered
Joined
·
236 Posts
he one in the sils is pretty good. even my MY00 323i in queensland summers of 45degreeC were still good but inside the doors the plastics has gone brittle. the power windows was good but the tweeter connection was pretty bad.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top