AE's are easy enough.... I have those cheap tube kind that require the little ballast thing to be hooked...
scary part was opening up the headlight cover.... but its just a few tabs, just dont use too much power..
for routing the AE lines through your headlight, take your headlight bulbs out, peel off the rubber housing (the grey rubber part where the bulb fits in), route out the wires and the rubber thing goes back on just fine.... If you have non-led AE's, i taped up the bllast things on top of the headlights inside the engine bay (there's more than enough space there).... routing the wiring to power is easy. just follow the instructions.....
scary part was opening up the headlight cover.... but its just a few tabs, just dont use too much power..
for routing the AE lines through your headlight, take your headlight bulbs out, peel off the rubber housing (the grey rubber part where the bulb fits in), route out the wires and the rubber thing goes back on just fine.... If you have non-led AE's, i taped up the bllast things on top of the headlights inside the engine bay (there's more than enough space there).... routing the wiring to power is easy. just follow the instructions.....
