BMW E46 Fanatics Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Hi All,
My the inverter that came with my wiring harness for my angel eyes went (3 months after I bought it) and I have been sent a replacement inverter from the supplier.

The problem is that the new inverter the supplier sent me is different then the one that came in the kit. I tried to wire this up in my original wiring harness and it is not working at all; the connections to the angel eyes are different. And the supplier is being NO help.

I can figure out that the red is power, brown is ground and the white leads are for the angel eyes but what do I do with the switch wire that goes to my ECU box, there is no place for it in the new inverter.

Ive looked at a couple of DIY's but none go into specific instructions for wiring this inverter.

Thanks in advance for the help.
 

·
Registered
Joined
·
5,438 Posts
The pic on the left is Inverter the Pic on the right is a relay....
 

·
Registered
Joined
·
24 Posts
Discussion Starter #5
I am able to remove the lens cover to install the inverter but I cannot access it because the headlight units are in the way.

How do you access the inverter on the P46s once the lens cover is off?
 
1 - 6 of 6 Posts
Top