E46 Fanatics Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
6,931 Posts
I am going to run BimmerBrakes New Equal Length Headers. I personally couldn't justify all the work involved just to gain the possibility of a few HP. But then again, if you really are pulling the head for porting, what the heck.

Not going to do anything to the motor until the summer or so. During that time, I will install Raceware HeadStud, Port and Polish, 3 Angle Valve Job the head. :)
Who's doing your head work ?
 

· Registered
Joined
·
6,931 Posts
Sounds good, take quality pics.
 

· Registered
Joined
·
6,931 Posts
That all sounds good. So when are you going to do the 35-70 WTQ (25-50 WHP) progressive nitrous wet shot between 2500-5000 RPM to get the torque up on your build ?


Rob :)
 

· Registered
Joined
·
6,931 Posts
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top