BMW E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 7 of 7 Posts

·
Registered
Joined
·
270 Posts
Discussion Starter #1
of your bumper away in order to make the Gen 3 tips fit. I was going to have Midas install this thing, but now I don't know. I don't want a sh*tty looking cut on my bumper valence. I think this applies only to 99 E46s.
 

·
Alpha Male
Joined
·
6,563 Posts
I have the Gen2 tips and have no problems even with my ACS add-on. just get them to bend the hangers so the tips are centered.
 

·
Registered
Joined
·
317 Posts
i got mine Gen III installed at midas too. The hangers that come on the exhaust don't really fit well. I had Midas make custom hanger and weld it on to the exhaust's brackets. After that, the tips fit under the stock bumper fine. there's no need to modify your bumper.
 

·
2 point five 3 two 3 i
Joined
·
3,915 Posts
Nope, I have the Hartge rear apron and the Gen 3 tips fit just fine. You should be able to adjust the hangers to get the correct fit.

:thumbup:
 

·
Registered
Joined
·
270 Posts
Discussion Starter #7
Well I think you're right, but I believe AA added the Gen 3 tips to this exhaust. I bought it used from thier garage sale section.
 
1 - 7 of 7 Posts
Top