E46 Fanatics Forum banner
1 - 2 of 6 Posts

· Registered
8 Posts
Discussion Starter · #1 ·
As always thanks for the expert insight and guidance ..

I'm the original owner of this noted 2002 325ci. Only 31k miles. I ordered it back then with the available "Sport Package" option.

For the lifespan of the car I've lived in a high-rise with an outdoor lot that is located about 200ft from a salt water bay. Needless to say the exterior of the car has suffered. The clear coat is starting to peel in various areas due to direct sun exposure. The aluminum trim and rubber seals have begun to show signs of deterioration as well. Considering - the car still looks decent. Eventually I'll address the exterior.

By the way - I've never had any mechanical problems with the car. Everything with regards to parts is 100% original outside of the windshield washer fluid pump, windshield cowl, rear brake pads, and the tires. Oil has been changed as needed. Air filter and cabin filter have been maintained as well.

Anyway -

Question #1 - I understand the design of the coolant overflow tank and I guess the radiator with the blue drain screw located under the car. I'm also aware of the bleed screw, located at the top of the overflow tank. I've read that there is another drain screw that will allow coolant mix drainage from the engine block. If so, is the coolant mix that is located in the radiator/overflow separated from the coolant mix located in the engine block? What's the correlation?

Question #2 - Regarding the brake calipers. All four are completely covered in surface rust. I understand that rust is inevitable, especially in my location. However, does this rust compromise functionality and/or safety? I will say the car brakes efficiently, with no indication of malfunction or pad wear. Should I consider having these replaced? If so, any recommendations, other than the $400 versions that BMW sells?

Thanks again..

1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.