E46 Fanatics Forum banner
1 - 5 of 5 Posts

·
Registered
2001 BMW 325xi A/T
Joined
·
17 Posts
Discussion Starter · #1 ·
The car was running perfectly fine, then off and sitting for about 10 minutes. I hop in to back out a friends driveway and it goes into limp mode (auto trans). Scan with a simple scan tool and get a P0600 code. Take the car home and scan it on INPA and I get code: 217 (CAN bus error -EGS Signal not present). It won't let me scan the transmission at all.
Next steps?
 

·
Registered
Joined
·
1 Posts
So the car was running perfectly fine. Car was sitting for about 10 minutes, off. Hope in to back out a friends driveway and it goes into limp mode (auto trans). Scan with a simple scan tool and get a P0600 code. Take the care home and scan it on INPA & I get code: 217 (CAN bus error -EGS Signal not present). It won't let me scan the transmission at all. Next steps???
"Any idea what happened, mine just did this same exact thing. 2000 323i 226k miles after trans failure. Replaced with same year trans, 120k miles.
Ran as it should for 3 weeks, slow down to stop at red light, light turns green and straight into limp mode.
 
1 - 5 of 5 Posts
Top