Hey guys i have an 2002 325ci issue. While i was driving down the highway at about 60mph i saw in my rearview mirror a stream of whit smoke. so naturally i checked my engine temp and all seem fine. so i decided to pull over and when i tried to accelerate nothing would happen, it had a hard...

I have a 2002 bmw 325i, and my flex plate broke because the transmission bolts came loose on me, I replaced that but didnt set my torque converter back in right and the shaft that goes into the flywheel snapped off. I was wondering if was ok to use the same torque converter until I can afford...

hi guys, i'm new in this group or website or ..., i don't know :D . i have a 330ci convertible with ZF5HP19 automatic transmission , and i'm about to tune it without changing my tranny to a manual or SMG one, so i'm not sure someone did this before or not, because i know always manual or smg...

Hi all. I've been having an ongoing transmission problem in my GM trans in in my 325i. I wanted to make a post as my problem has finally been solved, and it has been a total nightmare to try and discern in the past year. My car would have problems in 5th gear at low RPM (especially, but...

This is a follow up to my previous thread "Moaning at Freeway Speed". Asking for a little advice from my fellow fanatics. Been trying to chase down the rumble strip sound coming out of my car. I've always said that I thought it was in the rear end, and it only happens at 68 miles per hour and...

Symptom: On cars equipped with GM 5L40E transmissions only (A5S 360R/ A5S 390R): Loss of power/no movement in reverse (RWD), Loss of power/no movement in forward and reverse (AWD). Often happens only when the engine is cold. As far as I know, this problem does not generate any codes, or any...

The previous owner of my 04 325Xi had the automatic transmission fluid changed out by a local (non-bmw) shop. I just noticed when the weather got cold that the car rumbles at stop and in drivee. When the car is in neutral, there is no rumble. Its more like a shaking, car needs to go rumble...

I have a strange issue, my torque converter has been locking up very early, at about 25mph. I really notice this when I am turning at an intersection and accelerate afterwards. I have been doing so searching and seems like most people complain about their not locking up, but mine is locking up...