E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

stalling on startup

  1. General E46 Forum
    Hi! Thanks for wanting to help!! 2003 bmw 325i. (M54 - Automatic) Car ran really rough before I started work on it. Shaked/ran very rough....Had to put it in neutral at stop lights to keep the rpms up so it wouldn't stall. CODES before working on the vehicle: P0171 (system too lean Bank 1)...
  2. General E46 Forum
    In desperate need of help, to save my sanity. Been chasing trouble codes/cold start issue for several months. First post but not new to the forum. 2000 323i wagon, 125,xxx miles -On cold start, cranks and fires..immediately dies. -Crank and start anywhere from 2-5 times while pumping gas...
  3. General E46 Forum
    If anybody can point in me in the right direction on where I should check out first, it would be greatly appreciated. Car is 2001 330xi. My car was running real rough for a couple of days. shakey idle at around 600, dippin as low as 400 at times :facepalm: almost stalling out before catching...
  4. General E46 Forum
    So i have an issue with my 2000 323Ci. The car once in a while idles a little odd (goes up and down but has yet to stall) However driving it for a couple minutes it is alright But it does not happen all the time but i would like the fix it before it becomes any worse. I get the following...
  5. General E46 Forum
    Hey guys I have a problem. I have an 01 325i and every morning when I start my car it revs to about 1000 RPM then stalls out. After that the car is perfectly fine the rest of the day. This has been a progressive problem because it used to just rev to 1000 then stutter down to about 200 then go...
  6. General E46 Forum
    After reading various post on how dirty the ICV could get, I decided to take a look at mine. While furiously working on removing the horribly positioned hose clamps on the throttle body intake boot, I noticed that the line that runs to to the ICV off of the main air intake was just hanging in...
Top