E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of December's Ride of the Month Challenge!
1-15 of 25 Results
  1. E46 XI
    Hi Guys I bought a 2005 330xi nice and super clean, everything was good with the car on the first 3 months until it get overheated due a coolant reservoir leak, I stoped the car as soon as I saw the read light on my dashboard but that was the begging of my journey since then I get almost every...
  2. E46 General
    I have a cable that I bought on Amazon that lets me use INPA and NCS expert, but when I tried to use PA soft it wouldn't work. Is this a driver issue or do I need a different cable specifically for PA soft? Here's the link to the cable I bought...
  3. E46 General
    Hi guys, My car is E46 320D, manufacture year is 2000 (May). M47 engine. I have the rounded 20 pin connector under the hood. And I already have the 20 pins to 16 pin adapter and BMW scanner with PA soft already working fine. I want to know what Bluetooth scanner will work the best with my...
  4. Europe
    Hi, I have a 320D, the year 2000 with rounded connected in the engine bay. I have ELM 327 Bluetooth adapter and when I'm trying to connect with torque app, it does not connect to the ECU. Can you please name a compatible Bluetooth adapter for my car? TIA
  5. E46 General
    I had my car garaged for some time while I was painting it. When I finished the job and drove the car after, the ABS, DSC, and (yellow) BRAKE lights all came on. These lights will come back on immediately if I disconnect the battery and start the car - they do not need the car to be moving to...
  6. E46 General
    Hi there, How do I get the my E46 out of the permanent LIMP mode after I have fixed ignition problem? Background: My 2002 BMW325ci started working rough including in idle and within few days went into permanent LIMP mode (service engine light, little gear with exclamation mark next to...
  7. E90
    Hi, I'm totally new to the forum so please be gentle.... Just bought my first bimmer and one day after driving out of the garage the airbag warning has come on. The seat occupy warning is on at the same time despite either no one sitting in the passenger seat or the passenger having their seat...
  8. E46 General
    Hi guys, Today my seat heater started clicking off so I decided to throw the scanner on it (open circuit or short fwiw) but strangely pa soft said <not found> under DME. I've had it for months now, never had an issue checking the DME. Knowing some people ran into that problem if the pins weren't...
  9. Lighting
    2000 323i 207K. My driver's side headlight went out so i went to replace it and realized the bulb was fine. The next day the headlight popped back on only to go back out the following day. The driver's side rear bulb sensor went on however there was no bulb that was out. Did some digging in the...
  10. E46 General
    Dear Frirnds! How can I enable THE HORN SOUND (BEEE BEEE) using BMW SCANNER 1.4.0. as an addition to the simple alarm sound? I hope for your help)
  11. E46 General
  12. E46 General
    can we get a list going of top 10 OBD tricks and tips, prefebrally with instructions... S:clap:
  13. Driveline, Performance, Tuning
    So iv exhausted a lot of time and a small amount of resources so far trying to get this all to work with no luck. First off i drive a 2003 330I ZHP and consider myself a pretty smart guy when it comes to doing DIY's for this car and other cars, so i wouldn't be on here asking for help unless i...
  14. E46 General
    Will this work on our e46? If so, I'm going to buy it. Also, is the brand any good? http://www.amazon.com/gp/product/B0007LEG2K/ref=s9_al_bw_g263_ir09?tag=gmgamzn-20
  15. E46 General
    **ARIZONA*** Looking to see if anyone has a BMW code scanner for my E46 330i (2002). The one i require is the BMW scanner like PEake, snapon, etc. (not the OBD II scanner). Trying to figure out what codes I have since i have the E-brake, abs, dsc lights just came on. Any help we would be much...
1-15 of 25 Results