E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!
1-5 of 5 Results
  1. General E46 Forum
    Hi all - I have decided to put a vid together of my experience with using INPA (although limited to date), but also includes the mod to bridge pins 7 and 8 of the K-DCan interface cable. I also included a little stuff up I made when using the soldering iron, perhaps this will help others avoid...
  2. Mobile Electronics Forum
    hey guys i have a 323ci from -00 which i've been looking to get aux for the stereo to. i don't wanna get an aftermarket unit since it most of the time looks like sh*t to change to that in a e46. therefore i've been looking for a newer buisness stereo, the ones where it's possible to connect aux...
  3. General E46 Forum
    Hey all, I have an aftermarket CF hood, and being that I don't trust my half-not working stock latch, I have picked up a set of hood pins, and I'm wondering if anyone knows the best place to mount the anchor bolts that would stick up and go through the hood and that the pins would slide into...
  4. General E46 Forum
    Does anyone have experience with the aerocatch hood pins for CF hoods? I had sparco pins on my last car, but I always wanted to get the aerolatch ones because they look nicer. I need to know WHERE THE ANCHOR/BONNET FOR THE HOOD PINS WOULD GO. That's the main reason I started this thread...
  5. DIY: Do It Yourself
    I replaced the black rubber bushings for the guide pins on my rear calipers. Does anyone know if I am supposed to lube the inside and outside of these bushings or if I should put an adhesive on the outside so that it sticks to the caliper and then lube the inside where the guide pin goes?
1-5 of 5 Results