E46 Fanatics Forum banner
ms45.1

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. E46 General
    I have an 03 325i with the GM AT. The cluster was swapped from an ‘02 with less miles. I was trying to fix the FA, clear the tamper dot, don’t know wtf I did . . But the issue now is the DME. Temp gauge goes full hot when you turn ING on. Cranks fine, no start. There’s no CK ENG LT, trans is in...
  2. Forced Induction
    I recently did a turbo install on my 2004 325ci, m54, SMG, ms45.1 and I have run into the problem of knocking or loud pinging when at idle or cold, in addition to a very rough idle. Parts installed listed below. 35mm Bov Universal aluminum intercooler and 2.5inch piping. AEM boost gauge Oil...
  3. Driveline, Performance, Tuning
    someone is probably capable of deleting ews on ms45.1 i can pay if you want i got no start on my e46 since ive burned the ecu on a welding job and i just want to flash another ms45.1 from the junkyard to work with it pleasee helpppp
  4. Driveline, Performance, Tuning
    Hello everybody, MS4X developement group is proud to announce that MS45.1 now inside our scope. :) We want to open this thread for a MS45.1 related tuning exchange, because only in a larger group we will be able to understand the much complexer ECU compared to MS43. Our fellow board member...
  5. E46 General
    Hi all, just purchased a 2004 330i ZHP with 198k miles. No check engine light, but when I went to get my emissions test I failed due to all 5 OBD flags they check are showing not ready. I bought the car, then immediately drove 500 miles, so I figured the drive cycle would be good even if there...
  6. Driveline, Performance, Tuning
    Hi all, just purchased a 2004 330i ZHP with 198k miles. No check engine light, but when I went to get my emissions test I failed due to all 5 OBD flags they check are showing not ready. I bought the car, then immediately drove 500 miles, so I figured the drive cycle would be good even if there...
1-6 of 6 Results
Top