E46 Fanatics Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. E46 General
    So i have a automatic 2000 323ci that i can not get out of limp mode. It was in limp mode when i first got it and all it needed to fix it was a new maf and it worked. Now around a year later it is back in limp mode. I have tried putting in another maf and it did not work. I have found out if you...
  2. E46 General
    Hey guys! So I recently had clogged cats on my e46 325ci, so I swapped them out with headers and put 90 bungs in to kinda space out the o2 sensors from the exhaust stream. However, I’m still getting a check engine light and my car will still go into limp mode. So my question is if anyone on here...
  3. E46 XI
    So the car was running perfectly fine. Car was sitting for about 10 minutes, off. Hope in to back out a friends driveway and it goes into limp mode (auto trans). Scan with a simple scan tool and get a P0600 code. Take the care home and scan it on INPA & I get code: 217 (CAN bus error -EGS Signal...
  4. E46 Introductions
    Ok so my x5 wont recognize my obd2 sensor is on limp mode will not crank wont start. I redid all engine looms, replaced coils and plugs, got new maf, replaced gasket on disa, cleaned tps. New valve cover gaskets, new fuel pump, new intake manifold gasket, new solenoid. why is it now not...
  5. E46 General
    Hi Everyone, I am new to this forum, however, I hear its awesome. Anyways, my wife's 325i starting to go into limp mode after reaching 45 mph or 4k rpms. The EML light, traction control light and brake light would come on and the car would go into limp mode. As soon as she pulled over and...
1-5 of 5 Results
Top