E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
k+dcan
1-5 of 6 Results
  1. E46 General
    Hi Guys, Im trying to get INPA properly setup with my K+DCAN cable (from OBD Australia) for my 2003 320i e46 (from OBD Australia). I’ve apparently got everything setup, my cable drivers are installed and my com port for the cable is set to 1/my latency set to 1. When I connect to the engine M54...
  2. E46 General
    Hi all fanatics, I bought a cable like this one: https://www.ebay.com/itm/112678949484?hash=item1a3c30526c and installed INPA on my windows 10 I can just fine read all my data on engine and gearbox and see the value with INPA and the cable. I do only have one problem with the software and my...
  3. E46 General
    hello, ive used INPA for a longtime but after format something is weird. i used to have the black dot on ubatt when i pluged in the car and ingnition when i move the key to POS2. Now when i connect no dots but when i move to POS2 both of them light up. I know that is no problem to diagnose and...
  4. E46 General
    I've been spending the past few days getting INPA and other programs installed on my laptop. I soldered the 7 and 8 connectors on my cable and finally I was able to read my steering angle sensor status. I was following directions to re-calibrate it but when I hit shift+f4 to display compensation...
  5. E46 General
    Hi all - I have decided to put a vid together of my experience with using INPA (although limited to date), but also includes the mod to bridge pins 7 and 8 of the K-DCan interface cable. I also included a little stuff up I made when using the soldering iron, perhaps this will help others avoid...
1-5 of 6 Results
Top