E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!
intake
21-38 of 193 Results
  1. E46 General
    Hey guys. New to the forum, not new to BMW's. I have a 320i Touring with the 2.2L motor. I have the opportunity to grab the full intake off of a 325ci. So I'm wondering if there are any sizes differences in the 2 manifolds and/or throttle bodies? If there are, i'm definitely not expecting...
  2. Driveline
    See my other thread here for pictures and details. $270 shipped. $250 local pickup. This system (without extra filter or recharge kit, or pre-filter) retails now for $449!!! Fits E46 330's only due to the larger MAF sensor. PM me if interested or post up in this thread. I accept Paypal...
  3. Driveline
    I have a used authentic air intake for sale. Serial: 02-0106. The body is made of carbon kevlar and there are some damages to the rubber trim. All hardware is included (minus the bracket arm). I had no issues installing without the bracket arm. This will fit E46-320/323/325/328 (coupe/sedan). I...
  4. E46 General
    So, a while back I noticed that I was getting a certain whine/whistle from my m3's engine bay while driving. The whistle only appears when using light throttle at speed, maintaining speed, or when going downhill. The whistle generally starts around 2500rpm and gets drowned out by the engine...
  5. Driveline
    I have an Afe intake FS/FT. Im pretty sure that it is for a 323 or 328 because it does not fit my 02 330i properly. I am asking $150 for the intake because I am just trying to get my money back out of it. Let me know what you have. Here is the craigslist add for it. Thanks for your time ...
  6. E46 M3
    A couple weeks ago, I got an Eventuri intake and finally got around to installing it yesterday afternoon. The directions are very specific about how to install the MAF housing, but there's one issue: if I install the MAF housing the way their directions say to (and the way it came shipped from...
  7. Driveline
    aFe Intake $200+ shipping (http://afepower.com/afe-power-54-10441-magnum-force-stage-1-pro-5r-cold-air-intake-system) Stock springs $80 + shipping DSC module $75 + shipping Please PM me for items.
  8. Engine, Driveline, Tuning
    On an engine with Valvetronic such as my N46B20, does the Valvetronic negate the effect of an aftermarket cold air intake (when compared to the stock intake setup)? For this thread, the definition of an "aftermarket cold air intake" is going to be a cold air intake system in which the pod...
  9. E46 General
    Early this summer, I fitted a K&N cone filter directly onto my MAF tube as a replacement for the airbox altogether. It sounded awesome and ran great for a while, but then I installed an electric exhaust cutout and things fell apart. In addition to a blow ignition coil (which I swear must have...
  10. E46 General
    My 2000 323i wagon blew a coil 2 days ago and I replaced it same-day with a BREMI coil. Worked like a charm for all of 16 hours. Yesterday afternoon, out of nowhere, my car begins to shudder, lose almost all power, and throws SES, EML, and DSC. I pulled over, turned it off, waited 30 seconds...
  11. E46 General
    Last month I replaced both intake boots (20014 325 Ci) with stock parts from the dealer. With the lower boot fitted properly and the hard plastic collar/adapter in place between the upper and lower boots, the upper boot almost doesn't fit on the MAF. It is pulling down very hard and is causing...
  12. E46 General
    So I recently removed the factory airbox and installed a K&N cone filter. The sound is WAY better, but I'm worried that the intake is only getting hot air from the radiator. I have the M-Tech 1 front bumper, so there's a lot of scoop room down there, but the Xenon ballasts are too big to fit the...
  13. E46 General
    I just installed a k&n intake on my 330i e46. Sounds great exept the initial rev. From 500-1000 rpm there is a sucking sound. This has not happend untill intake was installed. The same sound happends shortly after shutting off the car. What is this?
  14. Engine, Driveline, Tuning
    Before anything, I did try searching for a bit before posting this. Car is a 2002 325xi sedan I had my headgasket let go on me yesterday, and the car is currently in the shop. As long as the head bolts don't strip in the block and the head is not cracked we will just resurface the head and be...
  15. E46 General
    Hi there! Iv got a problem which has gotten alot worse over time where my 328ci mpg has gotten almost half, only on motorways do I find it barely hovering at around 29, which even then sucks because it usually sticks around 34. In the city iv been getting 16 mpg which is crazy! My low end...
  16. E46 General
    Hey guys sadly my e46 is falling apart and its time to get a newer model. I have an 03 330i sedan with H&R racing springs, K&N 57 series intake, magnaflow catback, and HID fogs. I was wondering as I transition to my new E90, will I be able to use any of these parts? I'm guessing I can use the...
  17. Driveline
    I have a 330ci Gruppe M intake Non-M I'm selling. Currently on a 2005 330ci. Condition is good. No cracks on the shield. Just a little wear on the rubber. Trying to get my car back to stock so I can upgrade to an M5. Will try to post pics this weekend. Any questions pm me. SOLD to NoVAphotog...
  18. E46 General
    Thanks for some great info I have found on the forum here. :clap: We are making some great strides with my son's 330ci. It all started with a leaky valve cover gasket. While changing out VC gasket I decided to look into CCV and intake condition. Whew! Greasy-grime build-up. Likely, due to...
21-38 of 193 Results
Top