E46 Fanatics Forum banner
hoses

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. E46 General
    One day, about an hour away from home my fan blade exploded and cut my transmission cooler up so I acquired a new one. While uninstalling the line from the cooler I broke the quick connect fitting so I thought I could just throw some hoses over each end and clamp it and be fine. I was wrong. So...
  2. E46 General
    Hi again, Sorry for the weird title. Please see the attached pictures to know what I am talking about (FYI, the fasteners and hoses are on the drivers side of the expansion tank). The white plastic fasteners seen on the pictures (Red circles) were dangling around loosely. On the pictures I...
  3. E46 General
    Hello everyone. I'm getting ready to reinstall the intake manifold on the 2001 330ci coupe, manual transmission. I know which hoses go to #1, #2 and #3. But the two locations denoted by the arrows. I don't recall anything being connected to them, whatever they are. I'm under the impression...
  4. E46 General
    What's up everyone. I'm replacing most of the engine hoses in my wife's 2001 manual 330ci coupe. #1 & #2 in the picture are plastic hoses. Do these even need to be changed? I have the intake manifold off so if I'm going to change them, then now is the time. I also can't find a part # for hose...
  5. E46 General
    yah i did a refresh cooling system last week this is basically my thoughts and some side notes after the cooling refresh 1 radiator i went with the behr (oem) radiator it will not fit in that easy the first time there will be a 1 / 4 " gap on the screw bolt points (which you will need to...
  6. E46 General
    I recently had the radiator and Coolant tank replaced but now I have a leak from the upper radiator hose and 2 Little small hoses that are under the intake manifold.. Its kinda hard to see them but with a flashlight I can see a small puddle under them... I believe they are called heater hoses...
  7. E46 General
    I have a 2001 330i Sedan. I'm overhauling my heater hoses and am having a hard time verifying or identifying the three hoses I need. I already have the radiator hoses. 1) From the heater control valve to the firewall (64218376999, I think) 2) From the heater control valve to the very back of...
  8. E46 General
    Hey all, New to bmw with a 00 328i, and so far I have just replaced a control arm, cam pos sensor, and oil. Ignoring the rear differential thud noise for now, but it's at 108k miles, so it's general maintenance time. I have SES codes below that are I read with my generic code reader. I am about...
  9. E46 General
    Hey all, New to bmw with a 00 328i, and so far I have just replaced a control arm, cam pos sensor, and oil. Ignoring the rear differential thud noise for now, but it's at 108k miles, so it's general maintenance time. I have SES codes below that are I read with my generic code reader. I am about...
  10. DIY: Do It Yourself
    Sorry, if one has already been put together, but is there or can someone direct me to where I can get instructions on changing the hoses and ventilaor of the crankcase. A shop here in Tucson quoted me $1400 and I do not have that kind of money right now. So, if someone can please help me out.
1-11 of 11 Results
Top