E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!
fsu
1-8 of 8 Results
  1. E46 General
    I’ve been experiencing parasitic draw on my 330 for months now, and I’ve come to the reasonable conclusion that my problem is the final stage blower resistor (a common culprit). I also have an EML dash light in yellow, have had it for months. Could replacing the resistor fix this EML issue, or...
  2. E46 General
    Hi all, For some time I have no fan at all, so no windshield blower against condensation, which is a problem here with much rain! I'm talking about my 2001 320xi. So, I pulled out the FSU today and did ohm and volt readings as suggested. But there's no real comprehensive guide I think. I...
  3. E46 General
    When I bought my '99 323i the blower was stuck on and the fuse box had been soaked from the car sitting under a tree and pine needles clogging the drainage. I've installed two new FSU units, one cheaper one and a more spendy Behr. Both worked for the first few minutes then died. Both also got...
  4. E46 General
    Hey, So I'm trying to fix the heater in my 325i. I have no control over airflow direction. I can hear the fan going, but (currently) it doesn't come out of any of the vents. I just finished a Final Stage Unit replacement, and there is no change. I'm going to be selling the car to a friend, and...
  5. E46 General
    Just a general question. I'll be replacing mine soon. It's an interesting-looking bit of gadgetry. Are those heat sinks? What exactly does it do, electronically, and how does it do so?
  6. E46 General
    Hi there guys! I am new on the forum, but I have been reading for a long while, especially since I am having some problems with my ventillation system. First of all I noticed that the ventillation system does not blow any air on the windscreen. At all... first it was blowing air to the legs...
  7. E46 General
    :banghead:Battery flat after standing 3 days. I installed a new FSU. Recharged the battery. Guess what. Battery flat again after standing 3 days. It is a new battery (Bosch). All connections are tight. Ammeter does not show a drain. What to do now? Any advice please?
  8. DIY: Do It Yourself
    Here you go guys. Tools needed: - Philips screwdriver - Ratchet - 2" extension - 6-8" extension - Torx 20 bit - 1/4" adapter socket - 3/8" to 1/4" adapter - A pillow to lay on (if you want) Part number 64116920365 One tip that someone told me that you can skip is taking out the glovebox...
1-8 of 8 Results
Top