E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
fault code
1-8 of 9 Results
  1. Europe
    Sometimes if I accelerate at high throttle, it goes into limp mode. The fault codes: 4521 - boost control high Glow plugs (all) fault with controll unit tips on what can cause it? Thanks.
  2. E46 General
    Right, I had a code throw up for 02 sensor before cat bank 1, changed the sensor then was fine until a month later, changed again and the eml light kept coming up, found out the 30amp fuse in the ecu compartment was blown so i replaced that and still the same code every single time i start the...
  3. E46 General
    Hello all. I think (pretty sure, it's the automatic/ with semi manual option) I have a ZF transmission, and today it threw a code and put me in limp home mode. :banghead: It has only happened this once, and never slips, shifts hard or acts funny at all!!!! I was stopped in traffic, and heard a...
  4. E46 General
    Background: -guy backed into me with his SUV in a grocery store parking lot -his insurance accepted liability and I took it to a reputable body shop in Seattle (I'm new to the area) to get body fixed -car fix in about a week, body looks gorgeous but.... When I get the car back, the owner of the...
  5. E46 General
    Just got my Bavarian Techniq cable. Here is the results of the short test. If anyone can help me fix any of these problems please let me know what I can do. Thanks Customer Information Vehicle: 1999*BMW*328i*AM53 Production Date: 02 / 1999 Short Test Digital motor electronics MS42 for...
  6. E46 General
    Finally bought a Peake code reader for my '04 E46 after I failed emissions test. Read the code, reset and it came back. Code is 20 27CA DMTL Pump: Controlled. I know what the DMTL is, and what it does, but what does "Controlled" mean in this code? -Thanks
  7. E46 General
    Hi all, I'm reaching a dead end with trying to find out why my car seems to be using too much fuel...and hope someone on here can advise me on what could be causing it. Firstly my car is a UK model 1995 E36 2.0 with the M52 (6cyl) petrol engine, with vanos on the intake manifold. The engine...
  8. E46 General
    Hi, I've got a 2000 328Ci w/ auto trans. On cold starts w/ the car in PARK, the engine shakes. And when accelerating from a dead stop it studders. I'm getting fault codes: 15/08 (Mass air flow sensor) and 15/EF misfire on cyl#2. The car has not stalled and the ambient temps have been 60F+...
1-8 of 9 Results
Top