E46 Fanatics Forum banner
error
1-18 of 21 Results
  1. E46 General
    Hi Guys, Im trying to get INPA properly setup with my K+DCAN cable (from OBD Australia) for my 2003 320i e46 (from OBD Australia). I’ve apparently got everything setup, my cable drivers are installed and my com port for the cable is set to 1/my latency set to 1. When I connect to the engine M54...
  2. E46 General
    Hello! So i decided to read my car for codes and i got a few of them. Almost all of them are fixed except for one single code. The code says the following: "CAN: data storage difference to LZV". The thing is that i haven't found anyone that has the fix for the code and that's why im asking it...
  3. Engine, Driveline, Tuning
    Not sure if this is the best place Car is a 2005 BMW 330i ZHP I just ran the system check in torque and came up with this error shown in the picture TID: $e4 CID:$60 Max: 304 Current: 22,817 I did a quick search and couldn't find any information. Anyone have any ideas?
  4. Lighting
    Hi, guys i need you help in finding the problem with interior dome light. It fades in and out (not just regular flashing) while driving with daylights on. When i turn the headlight switch to off it stops flashing. i removed the whole dome light (the thing with 3 light bulbs on int) and tested...
  5. E46 General
    Hello, I've been having strange behavior from my AC lately. Hot air only from floor and defrost vents no matter what I manually set the AC and dash thumb wheel to. I've been reading about that a lot and I wanted to try to scan the IHKA system for errors and get some readings before I tried...
  6. E46 General
    Hi all, I've been trying to solve this issue for a few months and have looked through a lot of posts and done troubleshooting with my local Euro specialist mechanic with little success. I hope someone can give me some ideas. (PROBLEM): My DSC center warning light, ABS light, and BRAKE light are...
  7. E90 General
    Hi, I'm totally new to the forum so please be gentle.... Just bought my first bimmer and one day after driving out of the garage the airbag warning has come on. The seat occupy warning is on at the same time despite either no one sitting in the passenger seat or the passenger having their seat...
  8. E46 General
    I recently bought an 03 330CI (FA) and the previous owner changed the cluster to a 00 323CI (ZCS) because the original cluster was apparently malfunctioning. The amazing people on this forum helped me to solve a cluster lighting problem and I'm hoping you guys can help me to solve one of my...
  9. E90 General
    Hello everyone, I was unable to find the right thread for this forgive me if this has been covered. My auto transmission in my 2007 335i has been doing some odd stuff lately. When the car is warmed up and coming to a stop it seems to clunk and have hard downshifting between 3rd and second...
  10. E46 M3
    Hi! Occasionally after cold start I get a series of warnings illuminating. Usually lights stay on until i stop, switch off and then restart. After 2nd restart the lights initially illuminate but after a while one after the other are switched off. Reading possible error codes with OBD2 and Troque...
  11. E46 General
    So I recently just bought this car from probably the biggest D bag on the planet because he fixed everything with superglue, zip ties, and electrical tape. I've been going through the car and fixing things that go wrong with it. I have run into an issue though. Every morning, like clockwork...
  12. E46 General
    This is my first post. I have had six BMW's over the years and mostly repaired them myself with the help of sites like this. Thanks to everyone as I have learned much from this site over the years. I have an issue that I don't know where to go with. My 2000 328i has the general "check control"...
  13. Lighting
    I am experiencing an odd problem. When I got my car the tail lights in my trunklid were not working due to a bad ground. I have since had the ground re-wired, but now I am seeing an intermittent problem. The right side tail light will sometimes not work. The bulbs are new and both work 80%...
  14. E46 General
    There is a problem with the rear tail lights and reverse lights on my car. The lights were tested and it was determined that they were receiving power, but the ground was bad. After tearing the entire rear of the car apart and finding no damaged wires, loose grounds, or anything to indicate...
  15. E46 General
    I recently wanted to add an option in ZKE and when I went to go write the coding, it said it failed. Then after it came up with this error. Afterwards, all my previous coding in ZKE was lost and I cannot save anything in ZKE. However, I can write in LCM and other areas... I tried to turn the...
  16. Lighting
    Hi Guys, I just installed a set of aftermarket HID's in my car, but they're not working properly... I installed them using a relay harness connected to the jump terminal and grounded on the frame. Odd thing is, they work fine when the engine is turned off. No flickering at all ( I sat and...
  17. E46 M3
    Hi. Please I would like some quick answers. My motorlamp just came on, we read it and it said: " 0A: camshaft position sensor error code, wrong signal to crankshaft " or something like that. Car runs fine, no limp mode. Is this a sign of the sensor itself beeing bad or something else like a...
  18. Electronics
    The issues I had when I turned my car on: 1. turn signals dont light up inside but do work outside. (green blinker on cluster doesnt work) 2. seat belt light would not go off before and now its just off regardless if i am buckled or not. 3. sunroof switch intermitently doesnt work and does...
1-18 of 21 Results
Top