Search Results for ‘egs’

We took my brothers 2003 BMW 325i automatic to an indie shop a few years back and they alerted us they couldn't communicate with the transmission. Recently, we have been doing a ton of work on the car by ourselves and I have been using the BMW scanner to help get an idea of what is going on with...

My e46 by VIN was an auto model, I have a kickdown pedal and EGS error codes, but no CEL. Do I really need to flash from current 7795649( Part number 7793443) to a manual firmware RealOEM shows 2 manual options for my 2004/07 car - 13617801004 13617801006 I am afraid to brick my ECU...

The car was running perfectly fine, then off and sitting for about 10 minutes. I hop in to back out a friends driveway and it goes into limp mode (auto trans). Scan with a simple scan tool and get a P0600 code. Take the car home and scan it on INPA and I get code: 217 (CAN bus error -EGS Signal...

Bmw e46 330ci 2001 automatic Vin: JU73564 Hi everyone, So less than 24 hours ago, my car was running perfectly. I jacked it up to realign the bumper, took of the reinforcement plate to clean surfaces and finally reinstalled the black plate that protects the electronics box from the air intake...

Hi. I have a 2004 325xi. The ABS, transmission, Service Engine and a few other lights came on recently. When I read the codes, I got the following: FB: No CAN identification EGS 3E: No message from EGS control unit 3D: Activation, oxygen-sensor heater behind catalytic, bank 2 4F: Activation...

Hi All, So I tried to update my DME and EGS using WinKFP and I wasn't too successful... I ran into an error 211 and tried all sorts of things to remedy - to no avail. My car will no longer run. The Error Reads "Data Transmission to interface disturbed: 10GD8604 Here's a screenshot of the...

Hello everyone i have been reading this forum quite a lot, great help and a lot of good info, however this is my first post. i have a 328i 2000. My problem is as follows: sometime in the past like 1 year ago my transmission light and check engine light came on, and transmition went into fail...

I have a 2000 328i that is getting the dreaded "Gear Monitoring" code. I downloaded the Software for my EGS and reprogrammed it. The problem is still there. (Transmission downshifts from 5th to 4th for no reason and trips safe mode about 60 seconds later.) I am going to swap the EGS out next...

Here is a quick post on an issue i have had recently, and its conclusion. My car randomely went into "limp mode" and the red cog of death appeared, could not change gear and seemed like it was stuck in 3rd/4th. Also the ABS, brake, traction control light were all illuminated. It was working...

I have a 2003 BMW 325Ci. I have gone through 3 transmissions on the vehicle (the original, plus 2 reconditioned transmissions). The same problem continues to occur where I'm sitting in the car (at a stoplight, waiting for someone, etc.) with it in drive and my foot on the brake. There is a...