BMW E46 Fanatics Forum banner

dme

  1. No start after MAF HACK

    Driveline, Engine & DME Tuning
    Successfully got the DME into boot mode and upload the proper 512k file per the wiki and able to tune the calibration files just fine with ROMRAIDER. Trying to turn on the MAF hack using the community patch file in tuner pro and also in rom raider and load the 512k file back in using JM and boot...
  2. P1635 oil leak killed DME?

    General E46 Forum
    My 2005 330i zhp was running fine then power dropped and idle would surge from 1000 rpm to 1500 rpm. Did not respond to throttle. Checked engine codes and got P1635 and somtimes P1634 both about the throttle body adaptations. Did some searching didn't find much. Took the car to the Dealer and...
  3. MS42 EWS synchronize procedure...I need some help please!

    Driveline, Engine & DME Tuning
    Can someone please give me a step-by-step for re-aligning the EWS with the DME on MS42? I want to virginize the DME, make it work in my 328, then once start is confirmed, I'm going to custom tune from there. Well, DME is flashed with virginized BIN file, from the Wiki page, and now when i try...
  4. How to make a Bench Flashing Harness for your DME

    Driveline, Engine & DME Tuning
    If you get into tuning your MS43 DME you will most likely want the ability to flash your ECU on the bench. (without plugging it into the car) It's convenient, especially for Full 512kb DME flashes, which would otherwise be a two-person job. I spent a few days learning how to build my own cable...
  5. DME and EGS update Failed: Lost Bus & Diag Indexes

    Driveline, Engine & DME Tuning
    Hi All, So I tried to update my DME and EGS using WinKFP and I wasn't too successful... I ran into an error 211 and tried all sorts of things to remedy - to no avail. My car will no longer run. The Error Reads "Data Transmission to interface disturbed: 10GD8604 Here's a screenshot of the...
  6. Coding after engine Swap

    Driveline, Engine & DME Tuning
    Hi. Short story long, i have a friend that bought manual 2000(pre Facelift) 325 with a blown engine in which we have now transplanted the engine from an 02(facelift) Auto 330i. Before planning the swap i did some research and came to the conclusion that with the DME, EWS and key from the 330i...
  7. Oil Wicked Up Wiring Harness into DME Connector #3 (x60003)

    General E46 Forum
    Having recently rebuilt my DISA valve, but still experiencing odd drivability issues (random ST fuel trim spikes, despite low LT fuel trims; possible reduced gas mileage in city driving; and some odd but very brief engine stumbles at idle at least twice) I took a closer look using INPA at the...
  8. E46 Stutter between 2500-3000 rpm

    NY / NJ / CT
    Hi all Newbie here with a 2004 325Ci that has the stuttering issue between 2500 and 3000 rpm. I understand the DME needs to be flashed and that the dealer does not do it anymore. Is there anybody else who does this close to the Princeton area in NJ ? Thanks in advance Roshan
  9. Any E46 MS45.1 DME + EWS Service (New!)

    Miscellaneous BMW and E46 Parts
    People with cars built before 03/03 have a MS43 DME which has been publicly cracked and can be swapped into a different car with no issues. People with cars after that date received the MS45.1 DME which has not been publicly cracked and cannot easily be swapped into any car. Usually when...
  10. 05 ZHP MS45.1 Tuner recommendation

    General E46 Forum
    I am about to jump off the ledge and add headers to my 10/04 ZHP 330Ci 6speed Coupe. I’m going to do a few other things while I’m in there too like change oil pan gasket and motor mounts. Adding the headers will of course entail elimination of the post cat O2’s and the SAP (I have a block off...
  11. DME 45.1 tune with spare unit

    Driveline, Engine & DME Tuning
    I am seeking opinions on my plan to proceed with a tune for my 10/04 330Ci ZHP with a 6 speed. I have headers and a SAP block-off plate that I plan to install soon.:clap: I have found a tuner who has a good rep and can tune my DME 45.1ver. I also found a ZHP sedan that had a 6 speed at the...
  12. WTB AEM Infinity 708 ECU

    Engine & Performance
    Looking for an AEM infinity programmable plug-and-play stand alone ECU for S54 engine. INFINITY 708 - PN: 30-7109 or INFINITY 710 - PN: 30-7105 with or without harness. (P/N w/ harness: PN: 30-3510)
  13. Looking for DME tuning tools

    Que, Ont, NB, NS, Nfld, PEI
    I'm looking to flash my DME to EURO 2 on top of some other things, and am wondering if anyone in Ontario/Québec has the needed tools to do that. I'm looking to borrow or rent them this summer, I will gladly pay in either beer or money. :thumbsup: The issue is that my bimmer is in BC, and I'd be...
  14. Looking for DME tuning tools

    BC, AB, Saskatchewan, Manitoba
    I'm looking to flash my DME to EURO 2 on top of some other things, and am wondering if anyone in BC has the needed tools to do that. I'm looking to borrow or rent them this summer, I will gladly pay in either beer or money. :thumbsup:
  15. The Definitive EASY OBD USB THREAD E46/E36/E39+ - Complete Walkthrough 2017 edition

    General E46 Forum
    Images and more software guides coming asap, as soon as this line is removed, I have added all I will to the original thread Hello E46Fanatics and other folk, To start: This thread is entirely inspired and possible because of 'stevenluczynski' thread 'BMW USB OBD Diagnostic Thread'...
  16. Help me finish my engine swap

    E46 Engine Swaps
    Hey guys Just finished all the mechanical work of a 2.5 to 3.0 engine swap. I'm now trying to get the ecu recoded properly. I have winkfp working and edited the zusb value, but am now trying to get the adaptations and such reset. I'm not sure which software is easiest to use for this. I...
  17. BMW scanner 1.4 not reading DME all of a sudden

    General E46 Forum
    Hi guys, Today my seat heater started clicking off so I decided to throw the scanner on it (open circuit or short fwiw) but strangely pa soft said <not found> under DME. I've had it for months now, never had an issue checking the DME. Knowing some people ran into that problem if the pins weren't...
  18. Upcoming Chassis Swap

    General E46 Forum
    As the title says, I have an upcoming chassis swap which involves an auto to manual swap. They are both '99 323's but the one where everything is going into is from California with 100k less miles! I just wanna get a couple things clear in regards to the coding. Can I use ncs to remove s205a...
  19. Throttle body issues again :(

    General E46 Forum
    Hey everyone! First post on this forum but I'm having an issue that's driving me crazy! First off I have a 2000 323i made 05/00 I installed subwoofers (1600 watts) I turned up the volume and the car went into limp mode. Restarted it and the car ran fine. Fast forward 3 weeks it got to the point...
  20. Shark injector chronicles

    Driveline, Engine & DME Tuning
    I bought a shark injector software tune from turner motorsport for my 2005 330ci zhp and was a little weary to install it because of two reasons, the first being that I live in california and every 2 years I have to smog my car, and the second being that the instructions are littered with legal...
Top