BMW E46 Fanatics Forum banner

control arm bushing

  1. Lower control arm bushing

    Suspension & Braking
    Ive searched a few threads looking for answers and Im sure its out there. I have a 2002 325XI I am replacing the wishbone/balljoints and bushing. So the new "kit" gives me all the pieces except the bracket that holds the bushing (its just a bear bushing). Is there a way to seperate the old...
  2. Bad Control Arms

    Suspension & Braking
    Hey fanatics! So i noticed when changing my breaks that my driver side control arm is able to jiggle when the right side cannot. I am going to replace but was curious on What brands are good for control arms , Does the brand really matter and Do i have to replace in pairs or can i just replace...
  3. Control arm bushings

    E46 Xi Forum
    I have play in my Control Arm Bushings and the steering wheel has slight vibration at high speeds. Could this be causing the slight vibration. Just changed front rotors, both control arms and drive axle.
  4. DIY control arm bushing replacement, the easy way

    General E46 Forum
    There are lots of DIY for control arm bushing replacement. There are two tricky parts to the job: get the old bushing off and getting the new one on. To get it off I used a knife to cut the rubber and took off the outer metal sleeve, then I used a gear puller to pull off the remaining plastic...
  5. knocking noise at low speeds

    Suspension & Braking
    hi everyone. I'm new to E46fanatics and really need some advice and guidance. I have a 2002 325i (facellift) and recently there has been a knocking noise coming from the front left wheel. It used to be hardly noticeable but it's starting to get louder by the weeks. I only notice it at low speeds...
  6. Sub-frame reinforcement plate upgrade for Non-M

    General E46 Forum
    While replacing my CAB's I Found out my Subframe reinforcement plate was torn. After checking out Real OEM the Non-M and M part looked similar in their mounting holes. The M plate is beefier all around and has a scoop to vent air to the transmission, in addition to additional protection for the...
  7. 323i control arm bushing

    General E46 Forum
    I need to replace the control arm bushing for 2000 323i. I heard that it uses 60mm bushing. And BMW used to recall the car and upgrade to 66mm bushing, bushing house, and control arm. My question is that if I order 66mm bushing and bushing house, do they fit on the old control arm? I am going...
  8. Brand New Control Arm Bushings

    Suspension and Braking
    Hey there, I have a set of brand new control arm bushings (includes hardware) that I bought for my 2000 BMW 323Ci. They are for the FRONT control arms. Manufactured by Beck Arnley. I believe they will work on any rear wheel drive E46 but please ensure they will fit your car before you buy. I...
  9. Wtb fcab polyurethane

    Suspension and Braking
    Hi I need em for my 2003 330ci with 66mm bushings. Only preintalled in the lollipops please. PM with shipped to CA price plz!
Top