E46 Fanatics Forum banner
clutch replace
1-7 of 7 Results
  1. E46 M3
    So after 2 painful weeks I finally replaced clutch and flywheel in my 2004 SMG M3. Now I need to do a clutch adaptation but i'm not exactly sure how to. I have INPA but everything is in German. I looked everywhere but I just can't find a definite answer anywhere. Just wanted to see if anyone...
  2. DIY: Do It Yourself
    I bought a clutch kit thinking it came with the pilot bearing puller tool (extractor), but it didn't. It's a Saturday night and I have set aside hours tomorrow to work on this (the transmission is out and I have replaced the main rear seal, but without the tool, I am stuck. I don't want to order...
  3. E46 General
    Hi everyone, New to site and a new bmw owner '02 - 330Ci convertible from St. Lucia (Caribbean) BMW Clutch Kit (3 Piece) - Luk 21217523620 - $248.97 I just want confirmation that this is the right clutch i need, before i click the "check-out" button on "getBMWparts.com". Any feed back...
  4. Motorsports, Track
    I am setting up my dedicated 2001 M3 dedicated track car to run in NASA GTS-3. The car has full suspn mods, diff, tune, cage, exhaust etc but until now I haven't seen a need to change from stock clutch. My goal is to have less rev "hang" time for easier downshifting and possibly better...
  5. DIY: Do It Yourself
    Hello everyone, I have a 2.0L 2000/05 320d 136hp to 160hp with a repro or remap as you call it, i have it for 2 years from now. Everything fine but... dammm SAC... My clutch disk is reinforced with copper and Ferodo, my problem is that the pressure plate loses strength after 9000 km and start...
  6. DIY: Do It Yourself
    E46fanatics, I'm a Euro bmw e46 driver. I want to change my clutch on my E46 320 125kW Touring Euro (same clutch as 325Ci US). It has been in there for 130k miles and doesn't feel great. Shocks and studders a bit, grindy feeling in the pedle. Now I was wondering, why not go for a lighter...
  7. New England
    Replacing my clutch at 125K, too much slipping BMW Newport (Middletown) RI, quoted me $1350 for parts + labor. It is extra for the ball bearings to be replaced, which I will do. Price fair? Other place you recommend not too far from Providence RI? Thanks
1-7 of 7 Results
Top