E46 Fanatics Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. E46 General
    I was driving around a while ago and I shifted into 3rd gear and stepped on the gas and i had no power going to the wheels smelled a little burning assumed it was my clutch but didn't happen again until Today I was driving a bit hard and burnt my clutch and there was a bunch of smoke, and once I...
  2. E46 General
    I have a e46 330ci with 6 speed transmission. I installed brand new clutch FX250 from clutch masters. I have brand new stainless pivot pi, clutch fork, new slave cylinder and ECS ss clutch line. The car drove really good around 20 miles with no issues. Suddenly, the shifter did not engage but it...
  3. E46 General
    Any info is greatly appreciated. I have a 2003 330xi with ZF 6 speed. Just did a new clutch kit and flywheel. Got everything together and took her around the block; everything felt amazing! Nothing wrong for the short 10 minute drive. Parked the car, two hours later went for dinner. Put her in...
  4. E46 General
    I have a 2004 bmw 325i with a failing clutch, I’ve been trying to find the specifics of a clutch I would need to replace it with but I’m having a hard time finding sizing.
  5. E46 General
    I just bought a 2001 320d with 200,000 miles (I know) 🥵 And it is very very difficult to get the car into gear, but only when the car is running! When it is off the gears will select very smoothly. And also if and when I select first gear and release the clutch a little and then depress it fully...
  6. E46 General
    Hello everyone, I'm looking to get your recommendation on a new clutch. I'm driving a 2001 330i with just over 218k miles with the original clutch. Doing a search I see that they also make a conversion kit that replaces the dual flywheel with a solid flywheel. Has anyone done this? if so...
  7. E46 General
    On my way home today I experienced a major mechanical. Doing 70 mph up a slight grade in 5th gear my car began to feel rough, almost as if a tire was going flat. It did not pull or steer funny, so I began to get over when the engine reved high and I lost all power to the wheels. The shift lever...
  8. E46 General
    http://www.youtube.com/watch?v=E6yLY-AYo1A Hopefully the tow truck can get into my underground garage. Is it possible that I don't need an entirely new clutch assembly, but rather just one or two components?
  9. DIY: Do It Yourself
    Hello everyone, I have a 2.0L 2000/05 320d 136hp to 160hp with a repro or remap as you call it, i have it for 2 years from now. Everything fine but... dammm SAC... My clutch disk is reinforced with copper and Ferodo, my problem is that the pressure plate loses strength after 9000 km and start...
  10. E46 General
    bmw e46 3 series 2000 Folks my car broke down on the interstate and had to tow it to the shop.:facepalm: The only symptom I noticed was that the car was running at a higher rpm than it normally did. I have noticed it and took it to the dealer bmw of austin . I was told it may be because of...
1-10 of 10 Results
Top