E46 Fanatics Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!
brake booster
1-9 of 9 Results
  1. E46 General
    I need to replace my brake booster on my 2004 330Ci. I bought it thinking I'd do it myself, but it's seemingly a more daunting task than I'd originally thought. Has anyone had a shop do this job? On my model it's buried under the electronics box, not in the drug bin. How many hours did they...
  2. E46 General
    Hello lads my car is a 2004 325i. Recently I have been some problem, such as, the brakes would occasionally fail. It works most of the time, but if I happens to brake really hard, it will lose brake after that, as in the pedal goes to the floor, and the brake light goes on. Then after a while...
  3. E46 General
    I've been having an issue with my 2004 BMW 330ci. Some background; the vehicle ran perfectly fine for a long time. Regular maintenance done one day serp belt ripped. Before replaceing figure the alternator pulls was getting stuck. But when the new parts were installed everything seemed fine till...
  4. E46 General
    So, just bought a 01 325i. I believe i have a vac leak. I hear a air/hissing sound around my DISA valve so replaced it. Still a vac leak in the same area based off the hissing sound. Also my beak booster has a vac leak so my question is, is the break booster my problem?... to go more in detail...
  5. Suspension, Brakes
    Hi guys really need your help please read. 2003 e46 318 Ci m sport convertible I have a hard brake pedal when braking and little or no braking assist. I had my check valve changed and then my servo which fixed the problem. 3 months later I get the problem again with some uneven engine idling...
  6. E46 General
    -Got some things on a list of mine after I replace my front Rotors, Pads, and Bearings within a few weeks, and was wondering if there should be an order of operation. That is to say, I don't want to have any non functioning/ poorly functioning part mess up the the last job. E.G. If I replace my...
  7. E46 General
    Pulled the following codes P0300: Random/Multiple Cylinder Misfire P1349: Ignition System/or misfire P1351: Ignition System/or misfire P1352: Ignition System/or misfire P0171: System Lean (Bank 1) P0174: System Lean (Bank 2) Coils/plugs OK. Replaced exhaust camshaft sensor. Since both banks...
  8. E46 General
    hey everyone so i was proceeding to remove my brake booster after what happened in my previous thread (rubber grommet from brake booster vacuum line falling into the brake booster).... so i started to empty the brake fluid with a syringe and i noticed that there is a drain cap that is blocking...
  9. E46 General
    So here it goes.... Background: The last two weeks my car has been up on stands while I replacing my CCV (and upgrading to the cold climate version; car was originally a FL car so it didnt have the cold climate version), VCG, ofh gasket, vanos oil lines and some smaller gaskets/orings etc...
1-9 of 9 Results
Top