Good day all,
I'm about to do a brake job on my '03 M3 Vert (stock brakes, not comp) and I figured it would be a good time to do a small brake upgrade.
Originally, I was going to go with the 'CSL Upgrade Kit' but at $2k for what is essentially just a new comp rotor and a carrier for the STOCK...
I recently installed the 135i calipers on my e46 m3, all 4 calipers were installed,
fronts were installed with csl rotors, rally road stainless lines and reboot engineering caliper mount, no issues there looks and works great.
My issue is the fitment with the rear calipers, I...
Here is the link to the photo album.
So my front discs and pads are waaay overdue a change and so i had my eyes open for various big brake options. I had a look at the 6 piston BMW performance...
True floating rotors. Not semi-floating OE garbage.
2,000 miles. Purchased new from bimmerworld November 2013. No track time. No damage. Just went to a full 6 piston AP racing RadiCal kit.
Only reason for sale.
$650 an axle - picked up. In Lakewood, Colorado. Happy to meet folks coming...
These brakes fell in my lap right as I was about to pull the trigger a decent pad/rotor 330i setup for my 325xi, so I decided to make them work :)
Research online shows that you need to mill the m3 caliper bracket 6 or 7mm to fit non-M e46 cars. I went with 1/4" (mainly because my machine shop...
Getting a front Stoptech 2pc 14" (355mm) drilled 4 piston BBK for the PY.
Will be getting rear kit next year.
Not sure what colour to go with, lets see what e46f recommends.
Rims are RG63s in Anthracite
BBK for sale less than 10,000KM has been put on this kit it is in perfect condition.
It has been taken off a E46 330ci that was supercharged. This will fit any E46
as long as the Wheels are 19inch or bigger, as the wheels will not fit over them.
FRONT: 8 Pot front with...
Pics in post #14
After letting my Brembo BBk's and H&R coilovers sit in the floor for almost a year I've taken some "me" time to install them. I've rounded up a new set of SSR GT-3s to replace my old ones. After doing some test fitting I've found that I need a minimum of 5mm spacers in the rear...
Anyone know what the Brembo HP 1000 brake pad MOT (Mean Operating Temperature) is? This pad compound comes with BBK for the M3.
I'll be taking the car to the track and am curious if this pad is sufficient or if i should get better pads. I currently run Hawk Blues (MOT ~1050F) on stock...