Fuel Pump DIY postmortem - E46Fanatics E46 BMW Social Directory E46 FAQ 3-Series Discussion Forums BMW Photo Gallery BMW 3-Series Technical Information E46 Fanatics - The Ultimate BMW Resource BMW Vendors General E46 Forum The Tire Rack's Tire Wheel Forum Forced Induction Forum The Off-Topic The E46 BMW Showroom For Sale, For Trade or Wanting to Buy

Go Back   E46Fanatics > Tuning & Tech > DIY: Do It Yourself

DIY: Do It Yourself
Post here to share or improve your wrench turning skills! All BMW E46 DIY tips, tales, and projects discussed inside. Learn to work on your car and know the right BMW parts you will need!

Reply
 
Thread Tools Search this Thread Rate Thread Display Modes
Old 10-12-2019, 01:05 PM   #1
Alexotronic
Registered User
 
Alexotronic's Avatar
 
Join Date: Jan 2010
Location: Raleigh, NC
Posts: 395
My Ride: 2001 330Ci
Fuel Pump DIY postmortem

2001 330Ci 160k

I've owned the car since 2011, had a bit of difficulty cranking the car a few times. Battery voltage looked ok. Also had a couple instances of the car feeling sluggish.

DIY videos can make it look so easy sometimes.

Did the job with 1/2 tank of gas, seemed fine (the pump wasn't soaked)

The sound deadening was already cut, but there was an OEM pump, with OEM Clamp and a dab of glue between the ring and pump. (So maybe pump was replaced at dealer in the past)

Hardest part was the circular ring holding everything down. It seemed like I was hammering forever but getting nowhere - I marked the rings location before starting, so I saw that I was making a bit of progress.

Dropped the small brass punch I was using into the gap. Not getting that back, I just hope it doesn't rattle.

I didn't disconnect the pump + run the car, there wasn't much pressure when I took it off. My dad had a cone-shaped thing that I used to plug the line while I removed the pump. (I've read that some people can use a bolt)

Tried to snip the hose clamp, didn't work - it was easier to pry it apart.

New seal - getting the seal in-place then dropping the fuel pump into it worked well.

I didn't get the circular ring quite back to original position, but it seemed close/tight enough (maybe an inch off)

Replaced with VDO pump, (140$ from fcp euro) same brand as the OEM one, just without a BMW symbol on it.

only bled a little bit when I slipped hammering the ring off :-p
__________________

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by Alexotronic; 10-12-2019 at 01:05 PM.
Alexotronic is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Censor is ON



All times are GMT -5. The time now is 04:10 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
(c) 1999 - VerticalScope Inc. All rights reserved.