E46Fanatics - View Single Post - DIY: Guibo, center support bearing, transmission mounts.
View Single Post
Old 11-04-2016, 09:34 AM   #5
DEADF15H
Registered User
 
Join Date: Jul 2012
Location: Boca Raton, FL or Salisbury, NC
Posts: 2,184
My Ride: 2001 325i Auto
Model: 325i
Transmission: Auto
jjrichar,
Your attention to detail and pictures with designations embedded makes your DIY's the easiest to follow. I have the mounts and guibo sitting on my desk, wish I would have seen this sooner, as I would have ordered the center support bearing as well, Trying to determine if I am going to put the bearing off, until I get one in, and just doing, at least, the mounts.
I also used your Transmission Selector Switch DIY.
As these cars continue to age, your drive component DIYs will become more important to more of us. I just hit 182,000 so it's time to get this done, I can hear the noise during load on the driveshaft.
Thanks again for all the time you spent on this writeout, it is appreciated!

Last edited by DEADF15H; 12-24-2016 at 02:03 PM.
DEADF15H is offline   Reply With Quote