Been awhile since i updated. It took forever but the bolt finally came out, almost snapped on me had to use an extractor. I have replaced the sensor with a new oem Siemens one from ECS but I am still throwing code P0335 and I have my CEL and DSC lights still on along with my Brake Pad light but I think that's unrelated to this issue.
The good thing is that I was getting a bunch of misfire codes prior to changing the sensor now I only have 1 code. I tried to clear the code with my scan tool but it comes back after I start or drive it. The DSC light stays on when I clear codes.
It also has to be cranked for quite awhile before it will start. Battery, Alternator are new.
Anybody have any advice?
Last edited by Georgie336; 06-12-2013 at 04:05 PM.
Reason: added brand of sensor