E46Fanatics - View Single Post - DISA Question
Thread: DISA Question
View Single Post
Old 02-08-2020, 07:32 PM   #10
LeverThis
Registered User
 
Join Date: Jul 2016
Location: SF Bay Area, CA
Posts: 1,839
My Ride: 2004 325i automagic
Quote:
Originally Posted by dcminiman_43 View Post
I have a Viton O-Ring, just everything on this car is 16yo, and never did this or lower intake boot and both look so intimating and one of those scenarios that if I'm off on something when I replace there goes my mode of transportation I'm really nervous about the pin that holds the flap [emoji32]

Sent from my SM-N960U using Tapatalk
But you said the disa is brand new though, right? I think having the viton oring on hand is a good back up for the seal going bad if you remove it too many times, but the flapper pin should be good for years on a brand new disa. It's the original 16 year old disa's that lose the flapper pin.
__________________

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
:

20mm OD x 12mm ID x 4mm W : Viton O-Ring
3/4" OD x 1/2"ID x 1/16" Thick : Thrust Bearing/Washer
LeverThis is offline   Reply With Quote