E46Fanatics - View Single Post - P0365 Camshaft Position Sensor B
View Single Post
Old 07-11-2007, 01:53 AM   #20
dasha877
 
Join Date: Jun 2005
Posts: 26
Worked for me

I used this diy procedure and all went well. I'm little concerned about the bolt though. It took a beating while I tightened it, and I think it's a bit stripped. It bugged me enough that I tried to lossen it to make sure it could be done, and it did give way, but now I'm concerned about over tightening it and stripping it further. It's tightened only a quarter turn right now, snug, but not super tight...is this enough to prevent a leak?
dasha877 is offline   Reply With Quote