E46Fanatics - View Single Post - P0365 Camshaft Position Sensor B
View Single Post
Old 03-27-2007, 12:09 PM   #12
vert
Registered User
 
Join Date: Feb 2004
Location: VA
Posts: 578
My Ride: MINI Cooper Hatch
Send a message via AIM to vert
To confirm, the bolt is regular thread i.e. standing in front of the engine I would be turning left (toward the windshield fluid box) to loosen, correct? I tried last night but it would not budge. I need to get a better hex key though because the one i have is small with not enough leverage. I do understand there is loctite on the bolt, but wanted to check just to make sure before i start putting some pressure on it.

Also maybe someone can shed some light here. My CEL went on, I went to Autozone and read code P0369, asked them to reset then drove around. After a day CEL went on again. Went to Autozone and they read the same code again. Asked them NOT to reset the light. OK, at this point i confirmed the exhaust camshaft sensor so I went to the dealer and picked up the new sensor. Shortly after that while driving the CEL went OFF. I drove today it is still off. I am assuming i still need to replace the sensor, but wondering why would it go off.

Thanks.
vert is offline   Reply With Quote